PVC bunk bed – Make a bed suitable for two out of PVC pipes. Available at most sharpeners, PVC tubes offer an affordable, durable building alternative to wood. With the help of pre-cut pipes, these beds can be created quickly and easily. Place a solid plate of plywood during the horizontal pipe bars to create a stable platform that fits a twin mattress. An elevated lower bed allows for storage. For a single child leaving, consider the lower mattress platform and create a bunk bed. Create a 39-inch segment of the tube by connecting 11-inch, 17-inch and 11-inch segments of tubes with a T-piece between each. The middle opening of the T-connector must face upwards. Create a 75-inch segment by connecting four 18.75-inch segments with a T-piece between each. The middle opening of the T-connector must face upwards. Forms a rectangle from the two 39-inch segments.
Ideas for make PVC bunk bed, place a 4-way corner plug on each corner tube. Place a 4-way connector on each tube that is connected to 39-inch segments. Place a 5-way connector on segments over 75-inch segments. The middle section of the 5-way connector must turn inward. Create another rectangle by installing 11-inch, 17-inch and 18.75-inch sections of pipes between the plug fittings. This other rectangle should just reflect the one below. Create a mattress platform by mounting 39-inch segments between 5-way connectors. Place a sheet of plywood over 39-inch segments. Place a 36-inch segment of pipes in all the upward facing plug openings, except those on both sides. The 17-inch Segments
Then to make PVC bunk bed, place a 6 inch portion of the tube in each of the upward facing openings. Place the elbow plug on the cross stitches over 39-inch segments. These connectors should turn away from each other, towards the corners of the bed. Place an 11-inch pipe segment into each elbow plug. Place a 3-way corner plug on each corner. Create a handrail around the top of the bed using the tube segments, T-connector and three-way corner plug. Leave the room over 17-inch pipe segments empty because this is where the ladders will go.