4 poster king bed is one of life’s luxury and it certainly commands a price when you buy in the store. Build your own poster bed not cheap, but it will cost significantly less than any other handmade three poster bed on the market. A simple and modern design is surprisingly easy to make and you do not need master joiner skills to do the job well. Lay to 62-inch long planes of 2 of 8 loads in a row on a 2-inch edge, approximately 80 inches apart. Position 2 boards of 82 inches 2 of 8 wooden loads over the ends of the boards. The 62-inch planks will form corners with the inside edge of the 82-inch plank. The square of the 62-inch planks should perpendicular to the 82-inch planks, so ensure the planks along with 3-inch wood screws drive through the side of the 82-inch planks into the adjacent ends of the 62-inch planks each 3 inches. This is the basis of the queen size bed poster image.
Put four pieces of the 62-inch long 2 of 5 timber into the 4 poster king bed frame, slide them down to rinse with the floor. There should be two pressed against each end of the base and two evenly distributed in the middle. It will be 3 inches wide from the top of these 62-inch mattress support planks to the top of the bedside. Lay an 82-inch 2 by 3 sheet wooden trays flat on the work surface. Place two planks of 80-inch 2-times-4 load loads on each end perpendicular to the 82-inch shelf. Secure the two boards to the 82-inch shelf with four wood screws through each end. Repeat with two more 80-inch planks of 2-times-4 and a 2-by-3 board of 82 inches for the leg and side of the poster canopy.
Stand somewhere your legs upright so that the side 82-inch canopy is in the air and place your legs on either side of the bed bases. Have a helper help you lift the 4 poster king bed base to 5 inches from the ground and squeeze the base of four legs on this height, use on the carpenter’s square to make sure your legs are square with base. Station four 4-inch bolts through the side of each leg on the docking bed and the bolts on the inside of the base with associated nuts.